The set will then be placed inside the bucket. On the sides of the bucket, two more 1.25" holes are drilled opposite of eachother and a 1" piece of PVC that has small holes drilled lengthwise on one side is pushed through and the holes turned facing down so soil doesn't come through.
A small hole is drilled in the side of the bucket just below where the lid sits to act as an overflow spout to know when the bucket is filling and to allow extra water to drain in case it rains. The bucket is then filled with soil. After the bucket is full, remove the lid rim, place plastic over the bucket and use the rim to hold it in place. Then poke a hole in the plastic, stick your finger in the dirt, and plant a seed, covering it with soil. For the first week or so, water the bucket from the top to make sure the soil stays extra moist for the seed to germinate, then just keep the resevoir filled. If you have access to fertilizer, you can add about 4 oz of 7-7-7 and 4 oz. of Dolomite to the top of the soil, it will slowly release during the course of your plant's life. We didn't have this, so we used compost that had been made from the food scraps of the two children's homes with mango leaves, etc. In only 3 days we had about 30-40% of the 231 buckets that we made germinating and showing signs of life!
Hopefully this explains it a little better for you, we learned and adjusted as we went, set up a pretty efficient assembly line using about 10 people and were able to construct all 231 buckets in one full day, then filled and planted on the second day. These results could not be accomplished with just any group, we had a SUPER group that worked with determination and intelligence even though they had never constructed one of these before, and I had only made one myself. Special credit also goes to David Cole who by default became our agriculture expert and made a huge difference in our level of success by using his knowledge and experience with planting.
Questions?